1. Lower blowdown dewatering machine
2. Upper discharge
3. Fixed centrifugal
4. Mobile dewatering
1: The operator must be familiar with the structure, performance
and operation of the machine.
2: Turn the number of
turns before turning on the machine to check the running status of the switch.
3: The feeding should be
evenly distributed to avoid excessive vibration caused by excessively large
4: Do not brake the
opening and closing arm during normal operation to avoid damage to the belt
and other parts.
5: No items can be
placed on the top cover to avoid accidents after starting the machine.
6: If abnormal phenomena
are found during operation, the power should be cut off immediately and the
brakes should be stopped for inspection.
7: The machine must be
inspected regularly, filled with lubricating oil, and repaired at least once
every six months.
1: Put the material to be dehydrated evenly into the switch, pay
attention to balance, uniformity and overload.
2: After the motor is turned on for about 90 seconds, the machine reaches
normal operation, and the outlet pipe begins to discharge a large amount of
3: The machine runs for about 6-8 minutes. The outlet pipe is basically free
from water flow, and the power can be cut off. After 1-2 minutes, the brakes
are braked slowly and the machine stops.
4: Do not put materials into the machine during operation, so as to avoid the
high-speed rotating drum to break the material and injure people and objects.
1. The industrial dewatering machine is a kind of washing
equipment. It is a kind of equipment that uses the centrifugal force of the
inner cylinder to rotate and centrifugal force generated by high-speed
rotation to remove the moisture contained in the object.
2. Industrial dewatering machine, centrifugal dewatering machine is mainly
used in various spinning (needle) fabrics, garments, printing and dyeing,
food, hardware, chemical raw materials, latex products enterprises and
3. Industrial application is applicable to various metal parts after
grinding, cutting, oil washing, washing, cooling, dipping and anti-rust
liquid dehydration (oil), suitable for small hardware, electronic parts, iron
filings, aluminum filings, copper shavings Drying, dehydration, deoiling; and
electroplating and grinding processing plants, metal lathe processing plants,
hardware fasteners factories and other plants.
1: The industrial dewatering machine and the centrifugal
dewatering machine are all three-legged pendulum structure, which can avoid
the vibration of the foot during operation due to the imbalance of the load
inside the switch.
2: Industrial dewatering machine, the inner cylinder and outer casing of the
centrifugal dewatering machine are made of stainless steel plate material,
the switch is made of stainless steel plate, the cage base and the chassis
are cast iron materials, and the outlet pipe is below the chassis.
3: Industrial dewatering machine, the centrifugal dewatering machine main
shaft is made of high quality steel and heat treated.
4: Industrial dewatering machine, the transmission part of the centrifugal
dewatering machine is driven by triangular tape, and the centrifugal starting
wheel is directly driven by the motor, which can make the machine start
slowly and gradually reach the design speed to ensure the smooth running of
5: Industrial dewatering machine, centrifugal dewatering machine has a brake
opening and closing arm, which has good braking performance and can make the
machine stop quickly.